Pfaff hobbylock 795 Instruction Manual

21, Inserting the fabric guide plate: Open the work support. Insert the fabric guide plate as shown in the illustration. Close the looper cover and work support. After sewing the two-thread chainstitch seam, set the machine for overedge seaming as follows: Open the looper cover. Open the work…

14, Sewing a test sample Place a piece of fabric under the needle and lower presser foot. Hold thread ends with your left hand while turning hand wheel counter-clock wise with your right hand. Make sure that threads have interlocked correctly. After threading, a test sample should b sewn. Raise presse…

11, Threading the right looper: Turn the handwheel towards you until the right looper is in its farthest right position (see illustration below). Thread the right looper in sequence 1, 2, 3, 4, 5, 6, 7, 8 and pull approxima tely 10 cm (4”) of thread through the looper eye (the thread path is mar…

27, Changing upper knife: The upper knife is carbide tipped and will not need to be replaced with normal use. It has to be replaced only when the cutting edge has been damaged. Unplug the machine. Push the upper knife holder to the far right and turn the knob clockwise until it clicks. Unscrew the knife…

31, roblem 4achine does not 9ed material properly eedle breaks requently fhread breaks requently Sewing foot pressure on material too light 1. Needle is bent 2. Needle not correctly inserted 3. Fabric is pulled during sewing 1 Machine incorrectly threaded 2. Thread knots itself 3. Thread te…

22, Pfaff hobbylock 795 Thread chart :1 Material type Stitch type Thread Stitch lenc Cotton Size 80—100 Chainstitch Synthetics 2—3 mm Organdy, light knit Size 70—140 Light fabrics, fabrics taffeta, lining, Cotton silk, etc. Size 80—100 Overedge Silk 3—4 mm stitch Size 80—100 Synthetics Size 70-140 Cotton Size…