PERCo C-01 Assambly And Operation Manual

48, PERCo C-01 C-01 Controller Web-Interface 2.3. Setting of the access password of the controller By default, access password of the controller is not specified. To change or set the new password: 1. Click in the Web-interface menu: Parameters → Password. The page with working area will be …

6, C-01 Controller 3.1 Supported scanners 1 Scanners manufactured by «Metrologic»: - IS3480 Quantum E - MS 7120 Orbit USB - MS 7180 OrbitCG - 3310g Vuquest - MS3580 Quantum T Scanners manufactured by «DataLogic»: - Magellan 800i - (PSC) VS800 Scanners manufacture…

19, Assembly & Operation Manual 9. Connect the rest of necessary equipment. Follow the next recommendations in connection of: electromechanical (electromagnetic) locks and latches (Sect. 8.5); turnstile (Sect. 8.6); OD VCP (boom gates, gates etc.) (Sect. 8.7); RC-panel (WRC d…

12, C-01 Controller input IN2: o door sensor (reed switch) №2, o PASS2 output of a turnstile, o Optional equipment; inputs IN3, IN4: o optional equipment. Signals activation depends on description of their default status in Normal status of contact parameter (“normal_stat…

10, C-01 Controller Table 1. The purpose of connecting blocks of the bottom board Contact Purpose Connector XT1 (Inputs) IN1 «Door sensor OD1» or «Input for PASS A signal» GND «Common» IN2 «Door sensor OD2» or «Input for PASS B» or «Additional input» IN3 «Additional in…