Vernier Go Direct Energy GDX-NRG Manual 

1, 1 the power button once. The Bluetooth ® LED will blink red. 4. Launch Graphical Analysis 4. 5. Click or tap Sensor Data Collection. 6. Click or tap your Go Direct sensor from the list of Discovered Wireless Devices. Your sensor's ID is located near the barcode on the sensor. T…

2, Vernier Go Direct Energy GDX-NRG 2 In the most common configuration, the Load switch should be set to Internal 30 Ω Load. To use an external load, such as a pump, lights, buzzers, etc., set the Load switch to External Load. The Check Load LED, , will flash when Go Direct Energy detects that there is a potential between the red a…

3, 3 Water Resistance Go Direct Energy is not water resistant and should never be immersed in water. If water gets into the device, immediately power the unit down (press and hold the power button for more than three seconds). Disconnect the sensor and charging cable, and remove the battery. Allo…

4, 4 Item Order Code Vernier Variable Load VES-VL Vernier Resistor Board VES-RB KidWind Advanced Wind Experiment Kit KW-AWX KidWind Basic Wind Experiment Kit KW-BWX KidWind MINI Wind Turbine KW-MWT KidWind 2V/400mA Solar Panel KW-SP2V KidWind 12V/500mA Solar Panel KW-SP12V Warranty Vernier warrants thi…

5, 5 IC Statement This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation…