Wayne-Dalton 8000 Series Installation Instructions And Owner's Manual

7, two holes on the side of the left hand bottom corner bracket. Slide a clevis pin through the innermost hole, cable loop, and outermost hole, of the bottom corner bracket. Slide a washer onto the clevis pin and secure in place by inserting a cotter pin into the hole of the clevis pin.…

16, Wayne-Dalton 8000 Series Sound framing members Perforated angle Horizontal track (3) 5/16” Bolts and nuts Perforated angle bolted using (2) 5/16” x 1-5/8” hex head lag screws to ceiling member and parallel to door 5/16”-18 x 1-1/4” Hex bolts must extend into the track to serve as a roller stop 5/1…

11, Washer (1) 1/4”-20 Flange hex nut (1) 1/4”-20 x 9/16” Track bolt Top rail of horizontal track 1” x 4” x 23” Angle (if Supplied) Flag angle Flag angle (2) 1/4”-20 Flange hex nuts Bottom rail of horizontal track Vertical track (2) 1/4”-20 x 9/16” Track bolts …

10, manual. NOTE: The sections can be identified by the graduation of the factory installed graduated end hinges. The smallest graduated end hinge on section should be stacked on top of the bottom section, with each graduated end hinge increasing as the sections are stacked, see P…

1, This Installation document is available at no charge from: Wayne Dalton, a division of Overhead Door Corporation, P.O. Box 67, Mt. Hope, OH., 44660, Or Online At www.Wayne-Dalton.com. ©Copyright 2016 REV7_09/15/2016Part Number Table Of Contents 350140 PLEASE DO NOT RETURN THIS PRODUCT …

19, Limited Warranty Models 8000, 8100 and 8200 Wayne Dalton, a division of Overhead Door Corporation (“Seller”) warrants to the original purchaser of the Models 8000, 8100, 8200 (“Product”), subject to all of the terms and conditions hereof, that the Product and all components thereof w…