Videotec MAXIMUS MPX Instruction Manual

30, EN - English - Instructions manual 30 Use a 30mm wrench for tightly closing the threaded cap of the junction box. Make sure that there’s no gap between the threaded cap and the junction box tube after tightening the cap. Fig. 49 Finally tighten the set screw supplied for this purpose t…

65, Instructions manual - English - EN 65 10.2 Saving the current position (Preset) 10.2.1 Quick save Using the control keyboard it is possible to save the current position (for further information, refer to the manual of the keyboard in use). During the saving stage, it is possib…

67, Instructions manual - English - EN 67 10.11 Manual correction of a preset focusing Load the preset whose focus needs to be changed using the Scan command; change the focus using the appropriate keys Focus Far/Focus Near without changing the Pan/Tilt/Zoom position; then save the preset us…

53, Instructions manual - English - EN 53 9.6.10.2 Flat Field Correction Menu (Gain Switch Values) Once inside the Gain Switch Values menu it is possible to set one of the following parameters: 1. High-Low Threshold: Sets the temperature threshold used by the High-Low Population parame…

69, Videotec MAXIMUS MPX Instructions manual - English - EN 69 11 Maintaining and cleaning Before doing any technical work or maintenance on the device, make sure that potentially explosive atmosphere is not present. To reduce the risk of ignition, don’t open the device when a potentially explosive a…

3, Instructions manual - English - EN 3 Contents ENGLISH 1 About this manual ......................................................................................................... 7 1.1 Typographical conventions ......................................................................................…