Sartorius Signum 1 Service Manual

56, 56 Service Manual Signum Working with the Service Software Setting the XBPI-232 Protocol You need to set the scale to the XBPI protocol (BPI-232) in order to perform calibration/adjustment procedures or program the scale using the service software. – Switch the Signum scale off (…

33, 33 Service Manual Signum Working with the Service Mode 1-18-2 Entering the 1 st Linearization Weight – Scroll to menu code »1-18-2 « (by pressing the k key). Important note: The service mode must be active. – Access the input mode for the 1 st line…

26, Sartorius Signum 1 26 Service Manual Signum Working with the Service Mode 1-9-7 External Linearization with User-Defined Weights – Activate the service mode (see page 15). – Select weighing platform »WP1«. – Press the ) key to access the number menu. – Press the ) and k ) keys repeatedly to se…

19, 19 Service Manual Signum Working with the Service Mode Calibration/Adjustment Functions Important note: When using a verified weighing platform, open the cover on the back, left-hand side of the indicator housing. Then slide the menu access switch to the right (»free« setting). – Activate…

41, 41 Service Manual Signum Replacing Components ! AUT22916.JPG - + Z AUT22917b.JPG O1 U O AUT24188.JPG Z U Replacing the Data Output PCB Warning Disconnect the cable from the power source. Important note: Do not connect or disconnect live power cables to or from the equipment; a…

43, 43 Service Manual Signum Replacing Components AUT24194.JPG AUT24192.JPG AUT24197a.JPG AUT24192.JPG Replacing the System PCB Important note: Please refer to page 37, „Opening a Scale Featuring Strain Gauge Technology – Strain gauge scale with system PCB – When you repla…