Sunfire 12R Manual 

1, Electrical Requirements Your sunbed operates from a 120V AC source. You should have a NEMA 5-15R electrical outlet (below) capable of providing 15 Amp service, installed in the room in which you will use the unit. We rec- ommend installation by a professional electrician. The outlet must be eart…

8, SUNFIRE INDUSTRIES, INC. 4905 HWY 70 E, NEW BERN, NC 28562 • SUNFIRETANNINGBEDS.COM • 800-817-5083 To obtain warranty service visit www.SunFireTanningBeds.com. Proudly manufactured in the U.S.A. Date of purchase: Bench serial number: Canopy serial number: 1. Warranty Period: …

4, Using Your Sunbed Before using your sunbed, please note the following: • Your skin should be free of cosmetics, tanning oils, or other body lotions prior to tanning except for those specically made for use with tanning devices. However, do not remove natural body oils by bathin…

7, Canopy not tanning 1. Clean canopy, see Thorough Periodic Cleaning. 2. Replace lamps if lamp hours are greater than 800hrs. Lamps fail to light 1. Check source of AC power. Reset circuit breaker or replace fuse if necessary. 2. Make sure the unit is plugged into outlet. One or m…

3, Sunfire 12R 3 Assembly Procedures Lift the canopy to use it. The unit raises and tilts to position the lamps where needed for the optimum tanning position. 2 Screw the four casters into the stand legs. Use a wrench to tighten them. 1 Plug the three-prong 120V AC power cord into a dedicated outlet (see …