Subaru 2003 Legacy Service Manual

32, VDC-30 VDC REAR TONE WHEEL 11.Rear Tone Wheel A: NOTE As rear tone wheel is integrated with rear drive shaft, refer to “DS section” for removal, installation, and inspection procedures. <Ref. to DS-34, Rear Drive Shaft.> …

1, FUJI HEAVY INDUSTRIES LTD. G2300GE6 2003 LEGACY SERVICE MANUAL QUICK REFERENCE INDEX CHASSIS SECTION This service manual has been prepared to provide SUBARU service personnel with the necessary information and data for the correct maintenance and repair of SUBARU vehicles. This manual inclu…

20, VDC-18 VDC ABS SEQUENCE CONTROL B: SPECIFICATION 1. CONDITIONS FOR COMPLETION OF ABS SEQUENCE CONTROL When the following conditions develop, the ABS sequence control stops and ABS operation is re- turned to the normal control mode. 1) When the speed of at least one wheel reaches 10 km/h (…

28, VDC-26 VDC STEERING ANGLE SENSOR 7. Steering Angle Sensor A: REMOVAL The steering angle sensor must be always replace as assembly with combination base switch,if any problem is found,because this sensor can not be disassembled. Remove combination base switch assembly and refer to LI section for in…

9, VDC-7 VDC GENERAL DESCRIPTION C: CAUTION • Wear working clothing, including, a cap, protec- tive goggles, and protective shoes during opera- tion. • Remove contamination including dirt and corro- sion before removal, installation or disassembly. • Keep the disassembled parts in order and pro- …

21, Subaru 2003 Legacy VDC-19 VDC VDC SEQUENCE CONTROL 5. VDC Sequence Control A: OPERATION 1) Under the VDC sequence control, after the hy- draulic unit solenoid valve is driven, the operation of the hydraulic unit can be checked by means of the brake tester or pressure gauge. 2) VDC sequence control …