Stairville Tri Flat PAR Profile Operation & User’s Manual

22, If the unit is in DMX mode and a DMX controller is connected and turned on, the ‘d’ flashes in the first position of the display. When you configure a group of devices in master/slave mode, the first unit will control the other units for an automatic, sound-activated, synchronized show. Th…

19, Press the lock of the battery holder to the centre of the housing and pull out the battery holder like a drawer. Insert the battery. The battery is correct if the positive pole points to the housing base of the remote control. Slide the battery holder back into the remote until it clicks into place…

13, NOTICE! Risk of fire Do not cover the device nor any ventilation slots. Do not place the device near any direct heat source. Keep the device away from naked flames. NOTICE! Operating conditions This device has been designed for indoor use only. To prevent damage, never expose the device…

26, Stairville Tri Flat PAR Profile 7 [DMX In] DMX input. 8 [DMX Out] DMX output. 9 [Power Out] IEC chassis socket for the power supply cable to the next unit. 10 [Power In] IEC chassis plug for operating voltage supply, with fuse holder. Connections and controls LED PAR 26 …

46, 8 Technical data Number of DMX channels 3, 5 or 7 channels, depending on operating mode Lamp 18 × 3 W LEDs (RGB) Beam angle approx. 25° Mains power supply 100 … 240 V (AC), 50/60 Hz Power consumption 60 W Fuse 5 mm × 20 mm, 2 A, 250 V, slow blow Dimensions (W × H × D) 210 mm × 270 mm × 1…