Pyramid TTPROXEK TIMETRAX Elite Prox ek Quick Start Manual

4, Pyramid TTPROXEK TIMETRAX Elite Prox ek Connect & Mount Terminal Connect Ethernet cable into Ethernet port located in compartment on back of terminal. Connect power supply into power port located in compartment on back of terminal. Route the cables through channel at base of terminal. Mount terminal (see instruction…

3, IMPORTANT: Please write down serial # located on back of terminal before mounting. Write your serial # here:  SAMPLE Software Requirements Single User installation, Local Area Network (LAN) only DHCP enabled network Windows 7 or above All Windows updates must be installed p…

7, Wave prox badge within two inches of target area. If employee badge number is successfully read, the time clock terminal will beep and the badge screen. Employee records generated from prox badge punches are stored within the terminal. The ter - minal stores the last 6,000 punches before dow…

8, Copyright © 2016 Pyramid Time Systems. All rights reserved. I2214 Rev. H Call us 888.479.7264 EXT 1 Send us an email [email protected] Chat online pyramidtimesystems.com …

2, What you will need. Tape Measure Pencil Phillips Head Screw Driver Power Drill (Optional) TTPROXEK Terminal TimeTrax™ Proximity Badges (15) Part #42454 TIMETRAX™ Software CD Ethernet Cable (CAT5) TTPROXEK Quick Start Guide & TTELITE Series Software Reference Guide Power Supply S…

6,   Start time should be one hour after last Out punch of previous iod. 2 Click “Pay Class” from the “Setup” drop down menu. A default Pay Class has been set up. Click “Edit” to review all settings. Click “Save & Close”. If additional Pay Classes are needed, click…