SIG SIGRC76EGARFG Assembly Manual

15, 15 COWLING ❑ 47) With a glow engine you might prefer to not use the cowling, so that you have quick and easy access for engine adjustments and re-fueling. If you do elect to use the cowling, large openings will need to be made in the cowling to clear the engine cylinder head an…

5, The wings are designed as a 2-piece system, with separate right and left wing panels joined by an aluminum tube Wing Joiner and a hardwood locating Pin at the rear. Due to the high strength of the wing joiner tube, the wing panels do not need to be perma- nently glued together. Glu…

6, SIG SIGRC76EGARFG e) Turn the part over and glue the other side of the hinge. Con- tinue this process until you have glued both sides of all the hinges! Keep a rag handy to wipe off any excess Thin CA glue. (If you get some glue smears on the plastic covering, don't worry about them right now…

12, 12 METHOD 2 (4-5 cell pack): If your battery pack is small enough in height you can use the supplied plywood Battery Tray. This al- lows you to secure your battery to the tray while it is outside the airplane, and then slide the entire unit in place in the nose. Note that there is a tapered tab at…

9, ❑ 23) Figure out where and how to mount your receiver. This can depend on several factors, starting with whether you are using a glow engine or an electric motor for power. We decided to mount the receiver of our photo model, which will be electric powered, on the left side of the f…

8, a) First view the model from directly in front. Check to see if the stabilizer is level with the wing. You should find it to be very close. If necessary use a sanding block to fine tune the stabilizer platform to level the stabilizer to the wing. b) Next use a tape measure to m…