Sentry US T7PTZ-V23 Installation Manual

22, Installation Manual of HD-TVI Speed Dome 16 Chapter 3 In-door Mounting Applications Before you start:  For cement wall, you need to use the expansion screw to fix the bracket. The mounting hole of the expansion pipe on the wall should align with the mounting hole on the b…

35, Installation Manual of HD-TVI Speed Dome 29 Appendix Appendix 1 Lightning & Surge Protection This product adopts TVS plate lightning protection technology to avoid damage caused by pulse signal that is below 3000W, like instantaneous lighting stroke, surging, etc.…

3, Installation Manual of HD-TVI Speed Dome ii Regulatory Information FCC Information FCC compliance: This equipment has been tested and found to comply with the limits for a digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable…

27, Installation Manual of HD-TVI Speed Dome 21  If the dome is installed to the cement wall, drill three Φ5 mounting holes onto the wall according to the hole locations, and then insert the cement screws into the holes and finally use self-tapping screws to secure the mount…

38, Sentry US T7PTZ-V23 Installation Manual of HD-TVI Speed Dome 32 Problem Possible Reasons To Solve the Problem dome can be controlled but not smoothly. tightly. 2. RS485+ or RS485-wire is broken. 2. Change a RS485 wire. 3. The speed dome is too far away from the remote control …

5, Installation Manual of HD-TVI Speed Dome iv otherwise (which is not a malfunction however), and affecting the endurance of sensor at the same time.  Please use the provided glove when open up the dome cover, avoid direct contact with the dome cover, because the acid…