Humminbird Wide W Operation & User’s Manual

6, Use the bracket, which fits your transducer, and refer to one of the three following illustrations for the appropriate assembly instructions. Parts have been included for both installation procedures, so there will be some parts remaining. If you choose to install the transducer permanent…

8, When you have finished using the transducer, pivot the transducer body flat against the bracket and coil the cable around the assembly. The transducer and cable will fit into the center compartment of the Portable case for easy transport. Pivot the Humminbird unit all the way down…

3, Remove the two battery compartment lids by lifting upwards on the front lip. Locate the connector hardware kit and the transducer hardware kit stored in the battery compartments. Refer to the illustration and route the transducer cable through the rear of the mount base.…

7, You can mount the transducer anywhere on the side of the boat if your boat remains stationary. If you are trolling, it is best to mount the transducer on the transom of the boat. On fiberglass boats it is possible to place the transducer inside the hull of the boat in …

4, Humminbird Wide W Snap the support plate to the rear of the connector holder as shown in the illustration. Insert the connector holder assembly into place and use the two # 6-32 x 34 “ screws to fasten it to the mounting bracket. Install the Humminbird unit by sliding it onto the moun…

9, Repairs should be performed only by authorized Humminbird technicians. HUMMINBIRD ONE YEAR FULL WARRANTY… SERVICE POLICY…. WARRANTY… CUSTOMER SUPPORT… …