Humminbird 947C Installating And Operation Manual

44, NAVIGATE TO A WAYPOINT OR POSITION Navigate to the cursor position: From any Chart or Combo view, use the Cursor key to select a position or waypoint to which you want to navigate. Press the GOTO key. Navigation will begin immediately. Navigate to a specified waypoint: Press the GOTO key…

76, SETUP MENU TAB From any view, press the MENU key twice to access the tabbed Main Menu System, then press the RIGHT cursor key until the Setup tab is selected. NOTE: Menu choices will vary depending on system settings such as whether the unit is set for Advanced User mode and what accessories ar…

83, Humminbird 947C 78 ACCESSORIES MENU TAB From any view, press the MENU key twice to access the tabbed Main Menu System, then press the RIGHT cursor key until the Accessories tab is selected. If no accessories are attached to the Accessory Bus, no menu choices will appear under the Accessories tab. If an accessory is…

80, DEPTH OFFSET (Advanced) Depth Offset will adjust the digital depth readout to indicate depth from the waterline or boats keel. Enter a positive vertical measurement from the transducer to the waterline to read the depth from the waterline. Enter a negative vertical measurement fr…

67, 62 NAVIGATION MENU TAB Press the MENU key twice to access the Main Menu System, then press the RIGHT cursor key to select the Navigation tab. NOTE: Menu choices will vary depending on system settings. TRACKS Tracks allows you to view the Tracks submenu. T o view the Tracks Submenu: 1. Highlight Tr…

16, 11 TRANSOM TRANSDUCER INSTALLATION If you will be installing a transom mounted transducer, use the procedures in this section. There are several procedures you will have to perform in order to install a transom-mounted transducer. They are: • Determine transducer mounting location…