Trimble 4000SSE Operator's Manual

19, 16 December 1993 5 4000SSE Short Programming Sheet Program the receiver at least 20 minutes before scheduled start time. Turn the receiver on by pressing the POWER key. Receiver will boot and self test. Watch for any errors during self test. Press the clear key to display status of…

13, July, 1995 10 Figure 3-3 Trimble 4000SSE Front Display and Back Panel Ports ABC 1 JKL STU DEF MNO VWX GHI PQR YZ-- + 2 3 4 5 6 7 8 9 0 ALPHA TIME ENTER CLEAR STATUS SESSION LOG DATA CONTROL SAT INFO MODIFY Trimble POWER ALPHANUMERIC KEY PAD PROGRAM KEYS I/O 2 ANTENNA POWER 2 &…

28, Ver 1.0a July, 1995 25 ♦ Using the arrow keys move the highlighted cursor to the menu item “View Floppy Content - Floppy Directory Listing”. Press the <Enter> key to execute. A listing of the downloaded files on the drive will be listed just like above. Note the size of …

24, Ver 1.0a July, 1995 21 The computer’s screen will display: Note: The UNAVCO COMMANAD ASSISTANT helps with the programs and batch files commonly used in downloading both Trimble and TurboRogue receivers. This manual covers downloading Trimble receivers only. 6-3 Starting Trimble 4000…

26, Trimble 4000SSE Ver 1.0a July, 1995 23 6-7 Renaming files If files were named incorrectly or if the receiver is programmed to use auto-survey mode 1 (all files will have the same name) it will be necessary to rename the files before continuing the downloading process. To determine the correct name for each…

6, July, 1995 3 1.1.9 Downloading / End of Survey a. Stop the survey or watch the programmed stop and refer to Downloading Trimble 4000 Data chapter 6. b. Demonstrate the configuration of the download equipment. ♦ Demonstrate the setup of the OSM as an alternative to the download cable. �…