Promag TR510E Manual 

30, TR510E User’s Manual 30 activated. Each bell table entry consists of two fields: ‘time’ field (set through these 32 group-1 registers) and a corresponding ‘enable/disable’ field (set through group-1 registers 22H-41H). Bell table (Everyday mode), enable/disable (group-1 reg…

15, TR510E User’s Manual 15 R-command will be denied temporarily until all data sending finish. Note: When first time turn power-up for TR510E after received ‘R’ command, it will take 25 seconds to restore all factory defaults, in the meanwhile LED will display “INIT”…

26, TR510E User’s Manual 26 Set punch times (‘p’, 70H) Possible error codes: 04, 07 Command pNN Reply A NN- punch times in Hex form (00H-0AH), 00: disable, 01-0A: legal value for punch times. For some unknown reason device may be disconnected from network,…

8, Promag TR510E 8 3. Communications protocol The TR510E communications protocol is based on the GNET protocol specification. The serial communications parameters are 19200-8-N-1. If your PC software is through the serial port (RS232) to control the TR510E, you may create virtual serial port…

12, TR510E User’s Manual 12 NN is a machine (terminal) number in Hex form (00H-FFH), 00H is a “universal” number (see below for details). ‘D’ is a special command. It is used to select a particular TR510E terminal. All terminals power up in a “deselected” state. Each …

17, TR510E User’s Manual 17 Get group-3 registers (‘K’, 4BH) Possible error codes: 04, 07 Command KRR Reply Areg_datacc RR- register number (group 3) in Hex form (00H…FFH), reg_data is the data stored in the register, cc- checksum This command is u…