Sonel P-2 Operation Manual

4, Principal characteristics of the device: • Measurement of direct and alternative voltage presented on a display within the range between 1.5 and 750V with the maximum exactitude of 0.1V, • Indication of direct and alternative voltage on the diode indicator: 12, 24, 50, 120…

12, 10 6 Dismantling and utilization Worn electric and electronic equipment must be disposed of selectively, i.e. it must not be disposed of along with waste of other kinds. Send worn electronic equipment to a collection point in accordance with the act on worn electric and electr…

6, 4 1 Safety The purpose of the P-2 device is to test voltage and the continuity of connections as well as meas- urements of resistance. In order to guarantee the correct operation of the device and correctness of the obtained results observe the following recom- mendations: …

10, 8 2.8 Phase order test Note: The order of the phases may be determined so- lely in a three-phase system. 2.9 Illumination of the measured point The P-2 tester offers the possibility of illumina- tion of the measured area under difficult light condi- tions (e.g. in s…

8, 6 ment of voltage between L and PE. In order to avoid that connect the tester between L and N and after approximately five seconds switch the probe from N to PE. 2.3 RCD operation test In order to check the operation of the RCD switch whose nominal current is 10mA or 30mA it i…

7, Sonel P-2 5 2 Measurements 2.1 Control of operation of the tester Before each use of the tester, it is necessary to control its operation: • The voltage indicator must be tested using a known source of voltage, • Close the measurement probes – there should be an audible acoust…