Snorkel PRO 126 Calibration Manual

2, Snorkel PRO 126 IMPORTANT INFORMATION Before performing EMS trouble shooting or calibration, we recommend that you have the following tools at your disposal: 1. Fluke 88 or equivalent. 2. Calibration harness - Snorkel part no. 0191008 3. Three prong test plug - Snorkel part no. 0191025 4. Two prong test plug…

40, Page no. 5 - 8 Primary EMS errors that occur when joystick is at center (Continued): 2.2.2.2 Sensor error - check the boom length and angle sensors and their connections to the EMS controller. Replace them if necessary. The sensor reading should be within the appropriate ranges a…

45, Page no. 5 - 13 5.0 Trouble shooting for system calibration errors Generally, the operator need not and should not calibrate the control system. However, the valve calibration can be performed if the weather condition changes. The valve calibration is generally calibrated at oil temperature …

33, TROUBLESHOOTING DESCRIPTION INDEX 0.0 General Description 1.0 Primary EMS errors during power-up 1.1 All lights, except error light, and alarm flash on, but then error light and alarm remain on - self test fails 1.2 ERROR and CAL MODE light on after self test 1.3 ERROR light on aft…

38, 2.0 Primary EMS errors that occur when joystick is at center This section provides troubleshooting information for the primary EMS errors that occur when the operator is not operating the boom, i.e., the joysticks are not deflected. 2.1 Errors that stop the control system. Error light and alarm will…

39, Page no. 5 - 7 Primary EMS errors that occur when joystick is at center (Continued): 2.1.3.3 Sensor error - Check the boom length and angle sensors and their connections to the EMS controller. Adjust or replace them if necessary. The sensor reading should be within the following range. MAX MIN LENGT…