IMC Networks MediaConverter 1 Operation Manual

14, 14 The diagram below shows a typical application, followed by a table with three possible configurations. End to End Connection Switch TX/FX Half-Duplex Manually configure HDX Auto-Negotiation Off Full-Duplex Manually configure FDX Auto-Negotiation Off Full-Duplex Aut…

4, 4 About the MediaConverter The modular MediaConverter™ series includes modules which can convert copper to single-mode or multi-mode fiber at Ethernet, Fast Ethernet and Gigabit speeds, and can convert copper to thin coax at Ethernet speeds. Protocol-independent single- to multi-mode…

16, 16 Power Supply Installation When installing a redundant power supply module into a powered-on chassis, IMC Networks recommends setting the ON/OFF switch on the module to OFF (if present). After installing the power supply, set the switch to ON. If the redundant power supply module …

8, 8 The switch is labeled with “X” for a crossover connection (factory default) and an “ll” for a straight-through connection. Select the appropriate setting by moving the switch to the proper position before installing the media conversion module. If uncertain whethe…

21, 21 Safety Certifications UL/CUL: Listed to Safety of Information Technology Equipment, including Electrical Business Equipment. CE: The products described herein comply with the Council Directive on Electromagnetic Compatibility (89/336/EEC) and the Council Directive…

19, IMC Networks MediaConverter 1 19 LEDs on Power Supplies Power supplies include the following LEDs: • POWER Glows green when powered-on. Installation Troubleshooting During installation, first test the fiber and twisted pair connections with all troubleshooting features disabled, then enable these features, if desired…