Smoke Factory ENTERPRISE TC4 Service Manual

14, 5.3 Circuit boards 5.3.1 PCB ENTERPRISE TC4 Place the unit on one side. Disconnect all cables at the terminal block, the flat cable connector, the thermocouple and the power cable for the fan; see pictures below (5c-f). To disconnect the cables press a screwdriver in the hole above the cable…

10, 4.2 Testing/ Test plan 4.2.1 Pump EX5 230V/50Hz Optical test Test: Check if all tubes are connected properly, no fluid is escaped (see 3.3 Fluid circuit). Solution: If there are tubes disconnected reconnect them. Is fluid escaped somewhere, have a closer look to the tubes and fitt…

15, Smoke Factory ENTERPRISE TC4 Place the unit on the other side. Finally disconnect the flat cable 6-pin connector, see picture 5f. Picture 5f: Flat cable 6-pin connector Next drill off the rivet (see picture 5g) with a drill size 4mm carefully. Now screw of the four nuts fixing the board at the case with a spanner 5,5mm. I…

8, 3.3 Fluid circuit (Photograph) Picture 3.3a: Fluid circuit – one side Picture 3.3b: Fluid circuit – second side The fog fluid is coming from the fluid bottle [1]. It is flowing to the two pumps [2]. Coming out of the pumps the fluid is flowing via the pressure pipes to the HE. T…

2, 2 ENTERPRISE TC4 – SERVICE MANUAL SMOKE FACTORY FOG & HAZE GENERATORS 1. Introduction 1.1 General This document should be used if ENTERPRISE TC4 is not working properly. With this document it should be possible to find the fault/ not working device and change this device without the direct…