xpr B100PROX-EH-SA v2 Installer Manual

12, 12 Set RELAY 1 Time (on board) 1 swipe Set RELAY 2 Time (remote) BUZZER ON/OFF BACKLIGHT ON/OFF 2 swipes 3 swipes 4 swipes Wait 5 seconds (until fast blinking) Swipe the Installer Finger 1 to 4 times depending of the desired menu END END END END Installer Programming block diagram Swipe the In…

5, xpr B100PROX-EH-SA v2 NC COM NO Tamp Blue Yellow Red Black Pink Violet Orange Gray White PB RS485 + _ 12VDC POWER SUPPLY + _ NC COM GND (PB) PB + _ Electro Magnetic Lock Green Blue Yellow Red Black Pink Violet Orange Gray White Green Colour Connection Tamper 12V DC Red Black White Yellow Grey NC COM NO GND Gr…

3, Consult with installer about safety level of the installation. There are devices with relays compatible with this reader that can increase the security of the system if needed. One or two enrolled fingers are enough for one user. Ask the installer before he leaves the site to enrol…

6, 6 ADDING ADMIN FINGER 1.Push dip switch no.2 in position ON. 2.Reset the Power of the device. 3.Wait for One long + multiple short beeps 4.Put the dip switch in position OFF. (short beeps will stop) 5.Wait for about 15 seconds for the LED to blink in Orange. 6.Swipe the Master fin…

7, B (RS485) A (RS485) 1. Close the Jumper. DINRTT beeps continuously and the red led blinks. 2. Open the Jumper 3. Wait for Beep + OK Beep (short + short + long beep) After the OK beep, the coupling is done. P B2 G ND PB1 G N D NC1 COM NO1 NC2 COM NO2 A B T A MP TA M P R S485 GND +12V GN…

10, ADD Finger Relay 1 (on board) 1 swipe ADD Finger Relay 2 (remote) ADD Finger Relay 1&2 DELETE FINGER Change ADMIN Finger Enroll INSTALLER Finger 2 swipes 3 swipes 4 swipes 5 swipes 6 swipes Wait 5 seconds (until fast blinking) SWIPE new finger min. 6 times or present card/tag SWIPE alr…