Sagem MorphoAccess 200E Installation Manual

27, 22 23 NOTE: The Wiegand electrical interface conforms to the Security Industry Association Wiegand standard (March 1995). MorphoAccess outputs 26-bit Wiegand reverse. NOTE: To wire MorphoAccess for Dataclock out interface use the Wiegand cable as follows. Green = Data Out; White = Cloc…

80, SE32/03-011145-01 SAGEM SA document. Reproduction and disclosure forbidden. 53 E S The allowed values are: It is possible to upload the log file. For more information about this feature, refer to the MorphoAccess™ Host System Interface Specification, Ref.: 3000005996. Setting up time mask When usi…

85, 58 SAGEM SA document. Reproduction and disclosure forbidden. SE32/03-011145-01 E S Setting up Ethernet Link parameters You can use the Ethernet port to send the corresponding ID to the central security controller. Connection should be made using port 11020. Those configuration keys can …

53, Sagem MorphoAccess 200E 26 SAGEM SA document. Reproduction and disclosure forbidden. SE32/03-011145-01 E S If the identification is successful, the terminal triggers the access or returns the corresponding ID to central security controller. Once the person’s identification is done, the terminal automatically loops back, …

88, SE32/03-011145-01 SAGEM SA document. Reproduction and disclosure forbidden. 61 E S To activate or deactivate the COM1 port, you must select the SEND key in section COM1. The allowed values are: ID transmission on port COM1 is disabled when ILV communication is activated with key /cfg/Maccess/Admin…

19, 14 15 Memory module upgrade Gasket seal The word "DOWN" is printed on the lower right corner of the module. 5. Use approved static discharge protection. Remove the memory module from its protective ESD packaging. 6. Orient the memory module correctly by rotating …