Dodge 2004 Neon SX2 Diagnostic Manual

21, • When using the meter function, keep the DRBIIIt away from spark plug or coil wires to avoid measuring error from outside interference. 4.3 WARNINGS 4.3.1 VEHICLE DAMAGE WARNINGS Before disconnecting any control module, make sure the ignition is ‘‘off’’. Failure to do so could damage the…

536, Dodge 2004 Neon SX2 TEST ACTION APPLICABILITY 3 Turn the ignition off. Disconnect the Battery Temp Sensor harness connector. Disconnect the PCM harness connector. Measure the resistance between ground and the (K118) Battery Temp Signal circuit in the Battery Temp Sensor harness connector. Is the resistance below 100 o…

14, SETTING COMPASS ZONE The compass has a default zone of 8. Refer to the Zone Variance Map to determine the correct zone number. The correct compass Zone selection is crit- ical to proper compass operation. With the ignition in the ON position, pressing the Zone/Cal button (left reading…

742, for inspection or testing purposes. These systems, when fully charged contain fluid at high pressure. Before disconnecting any hydraulic tubes, hoses or fittings, be sure that the system is fully depres- surized. When servicing a vehicle, always wear eye pro- tection and remove any me…

287, If the DRBIIIt should display any other error message, record the entire display and call the Star Center. This is a sample of such an error message display: ver: 2.14 date: 26 Jul93 file: key_itf.cc date: Jul 26 1993 line: 548 err. 0x1 User-Requested COLD boot Press MORE to switch betwe…

228, TEST ACTION APPLICABILITY 4 Disconnect the Dome Lamp/Intrusion Sensor connector. Disconnect the Remote Keyless Entry Module connector. Measure the resistance of the Intrusion Sensor Signal circuit between the sensor connector and the RKE module connector. Is the resistance below 5.0 …