DFI EC200 Series Operation & User’s Manual

44, 44 Chapter 5 Ports and Connectors Chapter 5 www.dfi .com Front Panel Connector HDD-LED RESET-SW PWR-LED PWR-BTN 12 11 2 1 Front Panel HDD-LED - HDD LED This LED will light when the hard drive is being accessed. RESET-SW - Reset Switch This switch allows you to reboot without having…

26, DFI EC200 Series www.dfi .com 26 Chapter 4 Jumper Settings Chapter 4 COM 1/COM 2/COM 3/COM 4 RS232/422/485 Select All these jumpers on the system board are used to configure the COM 1 (JP15, JP23 and JP24)/COM 2 (JP17, JP25 and JP26)/COM 3 (JP19, JP27 and JP28)/COM 4 (JP21, JP29 and JP30) port to RS232, RS422 …

20, www.dfi .com 20 Chapter 3 Installing the Devices Chapter 3 3. Place the SATA drive (with HDD brackets) into the system. Align the mounting holes on the HDD brackets with the mounting holes on the heat-dissipating plate and then use the pro- vided mounting screws to secure the drive in p…

33, www.dfi .com 33 Chapter 4 Jumper Settings Chapter 4 COM 7 to COM 10 RS232/Power Select Digital I/O Power Select JP3, JP4, JP6 and JP7 are used to configure COM 7 to COM 10 to to pure RS232 or RS232 with power. The pin function of COM 7 to COM 10 will vary according to JP3’s, JP…

67, www.dfi .com 67 Chapter 8 Supported Software Chapter 8 Chapter 8 - Supported Software The CD that came with the system board contains drivers, utilities and software applications required to enhance the performance of the system board. Insert the CD into a CD-ROM drive. The autorun s…

39, 39 Chapter 5 Ports and Connectors Chapter 5 www.dfi .com 9~36V DC-in This jack provides maximum of 60W power and is considered a low power solution. Connect a DC power cord to this jack. Use a power adapter within 9~36V DC output voltage. Using a voltage out of the range 9~36V m…