DFI COM630-B Operation & User’s Manual

14, 14 2 Hardware Installation Panel Power Select JP5 JP3 is used to select the power supplied to the LCD panel. Important: Before powering-on the system, make sure JP3’s setting matches the LCD panel’s specication. Selecting the incorrect voltage will seriously damag…

36, 36 2 Hardware Installation Cooling Fan Connectors The fan connectors are used to connect cooling fans. The cooling fans will provide adequate airow throughout the chassis to prevent overheating the CPU and sys- tem board components. 1 3 Sense Power Ground Fan 3 Fan 2 Fan 1 13 Sense Power Grou…

10, 1 10 Introduction I/O Connectors Expansion Slots COM Express Connectors Dimensions • 2 connectors for 4 additional external USB 2.0/1.1 ports • 1 connector for an external serial port • 1 LVDS LCD panel connector • 1 LCD/inverter power connector • 1 Digital I/O connect…

5, Internal I/O Connectors ................................................................ 25 CD-in Internal Audio Connector ................................................. 25 S/PDIF Connector ..................................................................... 26 LVDS LCD Panel Connector…

38, 38 2 Hardware Installation Power Connectors 13 12 24 1 +3.3VDC +3.3VDC COM +5VDC COM +5VDC COM PWR_OK +5VSB +12VDC +12VDC +3.3VDC +3.3VDC -12VDC COM PS_ON# COM COM COM NC +5VDC +5VDC +5VDC COM Important The system board consumes a minimal amount of power. Due to its low power co…

20, DFI COM630-B 20 2 Hardware Installation The VGA port is used for connecting a VGA monitor. Connect the monitor’s 15-pin D-shell cable connector to the VGA port. After you plug the monitor’s cable con- nector into the VGA port, gently tighten the cable screws to hold the c…