DFI NS80-EA Operation & User’s Manual

15, 2 Hardware Installation 15 2.1 System Board Layout Chapter 2 - Hardware Installation NS80-EA (Supports IEEE 1394A and onboard LAN) J1 KB Mouse USB 1 USB 2 JUSB1 COM 1 (J4) Parallel (J6) COM 2 (J3) +12V power (ATXP1) 3 4 1 2 LAN CN2 USB 3 USB 4 Line- in Line- out Mic-in CN1 Phy AC�…

56, 3 56 Award BIOS Setup Utility 3.1.2.18 Onboard LAN Boot ROM (NS80-EA and NS80-EL only) Enable this field if you wish to use the boot ROM (instead of a disk drive) to boot-up the system and access the local area network directly. If you wish to change the boot ROM’s settings, t…

54, DFI NS80-EA 3 54 Award BIOS Setup Utility 3.1.2.7 Boot Up NumLock Status This allows you to determine the default state of the numeric keypad. By default, the system boots up with NumLock on wherein the function of the numeric keypad is the number keys. When set to Off, the functio…

40, 2 40 Hardware Installation 2.5.9 CPU Fan Connector Pin 1 2 3 Function Ground Power Sense The processor must be kept cool by using a fan with heatsink. Connect the CPU fan to the 3-pin fan connector at location J16 on the system board. The system is capable of monitoring the speed…

27, 2 Hardware Installation 27 2.4.5 RJ45 Fast-Ethernet Port (NS80-EA and NS80-EL only) The NS80-EA and NS80-EL system boards are each equipped with an onboard RJ45 fast-ethernet LAN port at location CN2 of the ATX double deck ports. It allows the system board to connect to a local area …

26, 2 26 Hardware Installation The system board suppor ts 6 USB 2.0/1.1 ports. USB 1.1 supports 12Mb/second bandwidth while USB 2.0 supports 480Mb/second bandwidth providing a marked improvement in device transfer speeds between your computer and a wide range of simulta…