DFI PS35-BC Operation & User’s Manual

73, 73 3 Award BIOS Setup Utility 3.1.4.2 Onboard Device Move the cursor to this field and press <Enter>. The following screen will appear. The settings on the screen are for reference only. Your version may not be identical to this one. USB Controller All Enabled Enables all USB por…

70, 70 3 Award BIOS Setup Utility 3.1.4 Integrated Peripherals The settings on the screen are for reference only. Your version may not be identical to this one. 3.1.4.1 OnChip IDE Device Move the cursor to this field and press <Enter>. The following screen will appear. The settings on the scre…

51, 51 2 Hardware Installation 2.6.11 LED DIMM Standby Power LED This LED will turn red when the system’s power is on or when it is in the Suspend state (Power On Suspend or Suspend to RAM). It will not light when the system is in the Soft-Off state. Important: If the DIMM Standby Power LED is ligh…

102, 102 4 Supported Software 4.2.2 Intel Graphics Drivers To install the driver, please follow the steps below. 1. On the left side of the autorun screen, click the “GRAPHICS” icon. 2. Click “Intel Graphics Drivers” on the main menu. The following screen will appear. 3. Follow…

20, 20 2 Hardware Installation 2.2.1 Installing the DIM Module A DIM module simply snaps into a DIMM socket on the system board. Pin 1 of the DIM module must correspond with Pin 1 of the socket. 1. Pull the “tabs” which are at the ends of the socket to the side. 2. Position the DIMM above the socke…

109, DFI PS35-BC 109 4 Supported Software 4.2.7 Microsoft DirectX 9 To install, please follow the steps below. 1. On the left side of the autorun screen, click the “TOOLS” icon. 2. Click “Microsoft DirectX 9” on the main menu. The following screen will appear. 3. Click “Yes” to continue. 4. Follow the p…