DG Airparts Super XC Instruction Manual

9, DG Airparts Super XC 25. Line up the servo control arm with the mark and mount the ser- vos in all four wing panels using your favorite method. 1. Slide the wing together using the main wing joiner and fit the wing to the fuselage. This may require some custom filing and sanding of the fuselage. 24. …

5, Flap Hardware 1. Flap Linkages (2) 2. Control Horns (2) Rudder Hardware 1. Pull-Pull Kevlar 2. 2-56 Threaded Rod (4) 3. 2-56 Jam Nuts (4) 4. 2-56 Clevis and Lock (4) 5. Control Horns (2) Parts List Rudder Hinges 1. Hinges (3) 2. Pockets (3) Page 5 Super XC Ai…

13, 2. Drill a hole at the mark using a 9/64” drill bit. 8. Using the popsicle stick as a guide, cut out the stabilator slot. If you feel comfortable you can do it directly with a Dremel® tool. Page 13 Construction Super XC 3. Glue the tow hook block in using epoxy and fill…

18, Page 18 2. Drill a 7/64” hole on the mark at the back recess line at approxi- mately 45° 4. Reinstall the wing and mark the end of each flap remembering to allow approximately 1/16” clearance. Construction Super XC 5. Temporarily set the flaps into position and transfer the mark …

4, Wing Bolts 1. 5/16” Nylon Bolt (4) 2. 5/16” Nylon Washer (4) 3. Wood Retainer Block (4) Elevator Bag 1. 3/16” Elevator Pivot Tube 2. Elevator Bellcrank Joiners 1. Main Wing Joiner 2. Outer Wing Joiner (2) 3. 5/32 Stabilizer Joiner 4. 3/32 Stabilizer Joiner Parts …

16, Page 16 11. Insert the fin post into the fin and verify the rudder swings at least 2” to each side freely. The top of the fin might need to be sanded further with the round sanding block. 13. Measure from the center of the setscrew to edge of the fin. 10. Reinsert all thr…