N-Tron 102PC-SE User Manual & Installation Manual

35, 12/1/2006 35 Scenario 4 – Serial Tunneling Mode This scenario shows a serial tunnel established between two serial devices (Serial Device-1, Serial Device-2) using two 102PC-SEs, which are geographically located apart. Serial Tunneling Commands for Module-1 (Configure for Seri…

21, 12/1/2006 21 o dtr Dialout session is terminated when DTR signal on the serial port s0 toggles from High to Low o none Dialout session is not dependant on the DTR signal Default: none Modem Configuration • Connect String: Sets the Modem Connect string Default: CONNECT • OK St…

36, 12/1/2006 36 Using E-Mail Features Mandatory Configuration Settings The following items must be configured in order to send e-mails : • Set the SMTP server address. # set send-mail smtp-server-name <smtp.servername.com> • Set the port number the SMTP server is using. …

33, 12/1/2006 33 Scenario 2 – Serial Auto Dial-in Using Telnet This example shows how to setup a serial auto dial-in session in telnet mode. The auto dial-in session is opened by telnet client in the 102PC-SE to the configured server on a configured port. Once the sessio…

10, N-Tron 102PC-SE 12/1/2006 10 GROUNDING TECHNIQUES The grounding philosophy of any control system is an integral part of the design. N-Tron switches are designed to be grounded, but the user has been given the flexibility to float the switch when required. The best noise immunity and emi…

28, 12/1/2006 28 Scenario 2 – Auto Dialout Using Telnet In this scenario, the Auto Dial-out session in Telnet mode is opened using a Telnet client. Prerequisites Raw mode (global and each port) must be either enabled or disabled using above-mentioned optional commands. …