ELECRAFT K3 Installation Instructions Manual

11, 11 Position the top cover on the K3. Note that the tab on the back center goes under the rear lip of the K3 rear panel. Secure the top cover with the nine 4-40 3/16” (4.8 mm) black flat head screws you removed earlier. REPLACE ALL THE SCREWS! The K3's chassis has excellent rigid…

10, 10 Plug the connectors on the wires leading to the ANT1 and ANT2 jacks into the KAT3 board as shown in Figure 7. ANT1 goes to the connector nearest the rear panel, and ANT2 goes to the one farthest from the rear panel as shown. Support the top of the KAT3 board when plugging in these con…

5, 5 • Wear a conductive wrist strap with a series 1-megohm resistor. If you do not have a wrist strap, touch a ground briefly before touching any sensitive parts to discharge your body. Do this frequently while you are working. You can collect a destructive static charge on you…

4, 4 Preventing Electrostatic Discharge Damage There is no climate or work location where the components of your K3 are safe from Electrostatic Discharge (ESD) unless you take specific steps to prevent such damage. Many of the components in your K3 can be damaged by static discharges …

2, 2 Contents Introduction...............................................................................................................................................3 Customer Service and Support...................................................................................…

1, ELECRAFT K3 ELECRAFT ® K3 HIGH-PERFORMANCE 160 – 6 METER T RANSCEIVER KAT3 100-WATT A UTOMATIC ANTENNA TUNER I NSTALLATION INSTRUCTIONS Rev B1, October 22, 2007 Copyright © 2007, Elecraft, Inc. All Rights Reserved …