Bulldog Security RS102 Owner's Manual

1, Bulldog Security RS102 CONTENTS REMOTE STARTER MODELS RS102/RS102E, RS112/RS112E, RS122/RS122E INSTALLATION GUIDE • OWNER’S GUIDE System Features ......................................1 System Components ....................................1 Required Tools .......................................1 Technical Assistance…

7, 6 MECHANICAL NEUTRAL SAFETY SWITCH (Rear Wheel Drive Only) When installing a Bulldog remote starter on GM vehicles or Dodge Dakotas built prior to 1996, you must: Use the diagram below to create a circuit that will prevent the remote starter from starting the vehicle unless the key…

2, SYSTEM FEATURES SYSTEM COMPONENTS TECHNICAL ASSISTANCE Should you need help. First check our website at www.bulldogsecurity.com/wires.htm or call our toll-free Tech Support Hotline Monday through Friday 9AM-8PM and Saturday 10AM-4PM EST at 800-878-8007. You must give the following informa…

5, 4. Use electrical tape to wrap, be sure to cover about 2 inches on either side of connection. Secure with wire ties as shown. 3. Lay upper twisted pair of wires over right wire as shown. Bring lower twisted pair of wires up to meet the left wire as shown. 2. Twist upper wires togethe…

8, 7 ANTENNA PLACEMENT E MODEL REMOTE STARTERS Run the antenna up the windshield pillar on the driver’s side and across the top of the windshield to the center, behind the rearview mirror. Use the antenna clips provided to hold it in place. Be sure to expose the full length of the clear a…

4, MAKING WIRING CONNECTIONS 4. Insert the wire from the unit through the hole as shown. 6. Use electrical tape to wrap. Be sure to cover the wire about two inches on either side of the connection. First pull the wire that you have just connected along side the wire you connected to, tape and wire tie…