Acura P/N 08E51-ST7-203G Installation Instructions Manual

10,  2000 American Honda Motor Co., Inc. – All Rights Reserved 10 of 10 BII 22288 (0010) 49. Remove the door harness through the hole in the door seal, then unplug the 6-pin connectors of the vehicle harness. Plug the 6-pin connectors of the door harness there. 6-PIN CONNECTOR OF …

9, 9 of 10  2000 American Honda Motor Co., Inc. – All Rights Reserved BII 22288 (0010) 45. Remove the bracket by removing the two self-tapping screws, then turn over the door seal in the direction shown. BRACKET DOOR SEAL SELF- TAPPING SCREWS 46. Remove the left screw from the …

2,  2000 American Honda Motor Co., Inc. – All Rights Reserved 2 of 10 BII 22288 (0010) Wire tie with clip 2 Flange bolts 6 x 12 mm Flange nut Door harness TOOLS AND SUPPLIES REQUIRED PhilIips screwdriver Stubby PhilIips screwdriver Flat-tip screwdriver Eye protection (face shi…

5, 5 of 10  2000 American Honda Motor Co., Inc. – All Rights Reserved BII 22288 (0010) 17. Remove the knee bolster (three bolts, and disconnect the connector). KNEE BOLSTER BOLTS CONNECTOR BOLT 18. Remove the footrest (two bolts). CLIPS DRIVER’S SIDE KICK PANEL CLIP (Turn …

8, Acura P/N 08E51-ST7-203G  2000 American Honda Motor Co., Inc. – All Rights Reserved 8 of 10 BII 22288 (0010) 35. Check that all wire harnesses are routed properly and all connectors are plugged in. 36. Reinstall all removed parts, except the driver’s dashboard lower cover. 37. Route the 3-pin c…