Adaptec 2120S - SCSI RAID Controller Installation And User Manual

125, D-20 Command Line Interface Switches /cache —Specifies whether to enable caching on the array. /stripe_size —Stripe size for the RAID 0. The default is 64 KB. /label —Label to assign to the new RAID 0. container create volume [/cache={ boolean }] [/label={string}] {device_ID}, …

114, D-9 Command Line Interface Enabling Automatic Failover To enable automatic failover, use the controller set automatic_failover command with the /failover switch, as in the following example: AAC0> controller set automatic_failover /failover_enabled=TRUE Executing: controller set auto…

163, Glossary-4 Glossary drive LED Indicator light that illuminates during read or write operations. E event Notification or alert from the system, indicating that a change has occurred. event log File used to maintain information about prior controller activities or errors. event n…

86, B-6 ACU for DOS Array Definition Block Keywords The array definition block always begins with the keyword Array and ends with the keyword End . The other required array definition keywords are Drives and Type. The array definition keywords are listed in the table below alphabetically…

107, D-2 Command Line Interface Introduction The Command Line Interface (CLI) allows you to configure and manage controller components. The CLI contains most of the functionality offered by Adaptec Storage Manager, plus some additional functionality not offered by Adaptec Storage Manager.…

139, Adaptec 2120S - SCSI RAID Controller D-34 Command Line Interface Enclosure Commands Note: You can use the enclosure commands only with enclosures that support Version 1.0 of the SAF-TE specification. enclosure activate slot {enclosure} {slot} Activates a device in a slot in the SAF-TE enclosure. Parameters {enclosure} —ID numbe…