Adaptec RAID 21610SA Installation And User Manual

116, C-17 Command Line Interface (CLI) Switches /always —Specifies whether to clear the array even if it has data on it. The default is FAL SE , meaning that the command clears the array only if it has no data on it. All user files must be closed; the /always switch cannot override th…

37, 4-5 Installing Adaptec Storage Manager – Browser Edition 11 When prompted to restart your computer, accept the default (Ye s) and click Finish. 12 The system restarts to complete the installation. 13 Remove the Adaptec installation CD before the system restarts. Configuring Internet …

89, Adaptec RAID 21610SA B-25 DOS Utilities Array Definition Block Properties The table below lists the properties that can be specified within an array definition block. The table lists each property’s keyword, whether it is required, and its default value (if any). Note that the keywords are arranged so the …

50, 5-9 Using Adaptec Storage Manager – Browser Edition Changing How Drives are Displayed By default, the Physical Devices displays a condensed view of the controller configuration that hides detailed information about the drives. More information is available by either positioning the…

70, B-6 DOS Utilities 5 At the DOS prompt, type afu list and press Enter. This command displays a list of the controllers in your system. Take note of the controllers you would like to update and its number (or numbers if there are more than one). Verify that the controller you wish to update…

142, E-1 E Specifications DC Power Requirements Current Requirements Environmental Specifications Note: Forced airflow is recommended, but not required. Volt ag e 5 V ± 10% Ripple and noise 50 mV peak-to-peak maximum Adaptec 2410SA 1 A maximum Ambient temperature 0 °C to 50 ° C Rel…