Clay Paky ALPHA WASH 700 Instruction Manual

14, 14 ALPHA WASH 700 Switching on the projector - Fig. 8 Press the switch. The projector starts resetting the effects. At the same time, the following information scrolls on the display: Model Firmware …

2, Clay Paky ALPHA WASH 700 2 ALPHA WASH 700 3 700W t c 150°C Risk Group 2 According to EN 62471 • Installation Make sure all parts for fixing the projector are in a good state of repair. Make sure the point of anchorage is stable before positioning the projector. The safety chain must be properly hooked ont…

26, 26 ALPHA WASH 700 2 3 4 1 Thermostat Lower Side Upper Side 16 Extraction of the effect modules: Preliminary operations - Fig. 16 …

35, 35 ALPHA WASH 700 • L AMP CONTROL (only with option LAMP DMX On) - channel: 18 I MPORTANT: Alpha Wash 700 is not provided with hot restrike igniter LAMP ON (FULL POWER) LAMP ON (FULL POWER) BIT EFFECT 255 180 0 101 1 00 LAMP OFF 179 26 LAMP OFF 25 UNUSED RANGE Lamp ignition after 5 s in fu…

18, 18 ALPHA WASH 700 LAMP DMX Used for enabling lamp remote control channel. 1) Press F - the current settings appear on the display (On or Off). 2) Use the UP B and DOWN C keys to enable (On) or disable (Off) the lamp remote control channel. 3) Press F to confirm the selection or LEF…

21, 21 ALPHA WASH 700 Continue ➔ LAMP HOURS Used for displaying the lamp working hours (total and partial). 1 ) Press F - Hours total and partial appears on the display. Total counter Counts the number of projector working hours with the lamp on (from manufacture to date). Partial cou…