ADIC FastStor 2 Install Manual

1, FastStor TM 2 6-00518-02 Rev B © May 2005, ADIC® ADIC, Scalar, and SNC are registered trademarks of Advanced Digital Information Corporation. All other product, company, or service names mentioned herein are the property of their respective owners. Installing or Removing a Barcode Read…

2, ADIC FastStor 2 2 FastStor 2 Installing or Removing a Barcode Reader Installing a Barcode Reader Use the following instructions to install the barcode reader to the rear of the autoloader unit. Use Figure 1 as a reference. Figure 1 Installing a Barcode Reader 1 Turn off your autoloader and remove …

3, FastStor 2 Installing or Removing a Barcode Reader 3 All barcode labels are applied to the front of the cartridge. Depending on the media type, barcode labels are either stickers that are adhered to the front of the tape cartridge or cutouts that you slide into an indentation on the front of the …

4, 4 FastStor 2 Installing or Removing a Barcode Reader Figure 3 Super DLTtape Cartridge Barcode Placement Configuring the Barcode Reader Your host system senses the presence of the barcode reader at power-up and enables the barcode read function. The application software can start scanning barc…

5, FastStor 2 Installing or Removing a Barcode Reader 5 Removing a Barcode Reader Use the following instructions to remove a barcode reader from your autoloader. Use Figure 4 as a reference. Figure 4 Removing a Barcode Reader 1 Turn off your autoloader, remove the SCSI cable(s) from the rear panel, …

6, 6 FastStor 2 Installing or Removing a Barcode Reader Contacting ADIC If problems cannot be solved with the aid of this document or if training is desired, contact the ADIC Technical Assistance Center (ATAC). In the USA: 800-827-3822 In Europe and Japan: 00-800-9999-3822 For other conta…