Condor 260 BAIT Installation And Operation Manual

15, 15 9. Connect the control box to the battery. There are 2 ways to power the control box a) Connect to a 9v alkaline battery In the package you can find a battery buckle, which is used to connect the cable to a 9v alkaline battery. …

31, 31 You can manually choose exiting the alarm mode by entering into Main Battery Alarm menu setting, and just changing the setting to a safe value will be ok. Boat Battery The Fish finder sounds an alarm tone when the battery strength of your bait boat is lower than the setti…

16, Condor 260 BAIT 16 Note: correctly connect the control box to the bait boat battery, and then you can monitor the remained voltage of your bait boat all the time. Avoiding using under a low battery. Note: the range of battery monitoring is 5.2~15v. Warning: be careful not reversing co…

40, 40 1501 Minnesota Avenue Winter Park, FL 32790 U.S.A. [email protected] www.condorsonar.com …

33, 33 5) Use the Up/Down Arrow to select the option. 6) Press Ent to confirm the setting. 7) Press Exit to exit the setting. System Reset System Reset is used to restore original factory setting. To set the System Reset: 1) Press Menu to enter into menu setting. 2) Repeat…

23, 23 1. Sonar Sensitive Sensitive determines how echoes will be displayed on the screen. Increasing the sensitivity will make you see more details on the screen. In deep water, increasing the sensitivity. whereas in shallow decreasing the sensitivity. In mo…