Continental Girbau CG145-55 Installation Manual

34, 30 a. The pressure of the condensate in the steam supply will cause water hammer and subsequent heat exchanger (steam coil) failure. The steam supply connection into the main supply line must be made with a minimum 12-inch (30.48 cm) riser. This will prevent any condensate from dra…

25, 21 F. ELECTRICAL INFORMATION 1. Electrical Requirements It is your responsibility to have ALL electrical connections made by a properly licensed and competent electrician to assure that the electrical installation is adequate and conforms to local and state regulations or codes. In the absenc…

51, 47 e. Open main door. The dryer must stop and ALL indicator lights on the back side of the microprocessor controller (computer) board must go out. (Refer to the illustration on the previous page.) f. Try to restart the dryer with the main door open. g. The microprocessor controller (compu…

44, 40 SECTION V WARRANTY INFORMATION A. WARRANTY For a copy of the manufacturer’s commercial warranty bond covering your particular dryer(s), contact the distributor from whom you purchased the equipment. If the distributor cannot be contacted or is unknown, warranty information can be obtained …

7, Continental Girbau CG145-55 3 SECTION I IMPORTANT INFORMATION A. RECEIVING AND HANDLING The dryer is shipped in a protective stretch wrap cover with protective cardboard corners and top cover (or optional box) as a means of preventing damage in transit. Upon delivery, the dryer and/or packaging, and wooden skid should …