Count EZCREASER Operation & User’s Manual

2, INTRO LETTER Congratulations, You have purchased the most versatile automatic creasing machine on the market today. Designed to accommodate the demands of finishing digitally produced media, the EZ Creaser efficiently applies a rotary actuated compression crease, leaving a cri…

22, ADJUSTING THE RAC ROLLERS The RAC rollers are set from the factory and it is NOT recommended to make any adjustments to this without consulting with Count’s tech-support department. Should an adjustment be necessary, please follow the steps below. Loosen the small beari…

28, SERVICE DIAGRAM C EZ CREASER BASE ASSEMBLY ITEM NUMBER PART NUMBER DESCRIPTION 1 H-0466 WASHER, 1/4I.D. 3/8O.D. 1/32 THICK 2 H-0465 WASHER, 1/4" NYLON 3 H-0285 SCREW, 1/4-20X1…

9, TRANSPORT OPERATION • A document may be slowly advanced through the transport by pushing and holding this button. EXAMPLE: The motor should advance transport at slow speed and stop whenever finger is lifted. • Controls on-off function of motor. …

21, RAC System (Rotary Actuated Creasing) Assembly Component ID A. RAC drive motor B. Eccentric Drive Shaft C. Upper crease die D. Pressure Adjust bearing blocks (RAC Rollers) E. Lower crease die F. Drive chain & tensioner SEE DRIVE CHAIN TENSIONER ON PAGE 13 G. Return …

13, Count EZCREASER FEED TABLE ASSEMBLY Nut –Adjustment Feed – F-0640 Micro-Lateral Adjustment Lock – F-0645 When positioning is correct, this will lock the adj. knob in position Micro Skew Adj Knob – S-APP-0005 Releases and tightens feed rails to ( knob T …