CPC 1987 Arctic Cat Super Jag Service Manual

22, Fig. 2·43 • CAUTION • Water or cleaning solvent must be used in con- junction with the wet-or-dry sandpaper or damage to the sealing surface may result. CYLINDERS 1. Using a non-metallic carbon removal tool, remove carbon buildup from the exhaust ports.…

131, 1. Inspect all mounting bolts for any signs of thread damage, bending, bolt stretch, and wear. If any of these conditions are found, replace the bolt. 2. Inspect all axles for signs of cracking or wear. Check each axle for tightness in its bushings. …

8, 8. With the ignition sw it ch key in the OFF posi- tion . A. Disconnect the high tension wires from the spark plugs; then remove the plugs . B. Pour 29.5 ml (1 fl oz) of SAE #30 petroleum - based oil into each spark plug hole and pull the recoil handle sl…

11, ... """", Engine Specifications • mm 60 x 60 65 x 65 65 x 65 (in.) (2.362 x 2.362) (2.5 59 x 2.559) (2 .5 59 x 2.559) cc 339 431 , (cu in.) (20.68) (26.29) mm 0.15·0.80 0.20·0.83 (in.) (0.006-0.031) (0 .008-0 .0 33) Piston Sk…

68, CPC 1987 Arctic Cat Super Jag • • 8. Check the face of the sheave in the area of the thr ee newly drilled holes. If any sha rp edges are found, s mooth area using fine emery paper. ASSEMBLING Fig. 4·36 KEY 1. Sheave, Stationary 2. Sheave, Movable 3. Ramp, Clutch 4. Washer, Lock 18…

18, • Fig. 2·26 025 7. Using a spanner wrench to secure the crankshaft, remove the three bolts and lock washers that secure the starter pulley and fan pulley to the flywheel; then remove the starter pulley. Fig. 2·27 026 8. Using a screwdriver, p…