CYCLOPS PARALYSER 165 Manual, User Instructions

5, PROBLEM SOLVING System won't disarm (LED won't flash or extinguish) ! Make sure that ignition switch is in the OFF position. ! Make sure the vehicle battery is not flat. ! Try your spare Touchkey. ! Use PIN to over-ride and contact you nearest Cyclops service centre. SPECIFICATIONS Manuf…

1, CYCLOPS PARALYSER 165 PARALYSER 165 USER INSTRUCTIONS CYCL PS R U I C T Y E S S S Y S M T E Proudly designed and engineered in Australia by Dynamco Pty Ltd. …

8, WARRANTY REGISTRATION PURCHASED FROM OWNER’S NAME TYPE OF VEHICLE VEHICLE REGO MODULE OF UNIT DATE OF INSTALL’ WARRANTY PERIOD : AFTER HOURS EMERGENCY PHONE CONTROL MODULE TOUCHKEYS CYCL PS R U I C T Y E S S S Y S M T E …

7, WARRANTY Subject to the conditions stated below, to be free from manufacturing defects and faulty material within the warranty period stated below. CONDITIONS !That the warranty registration has been completed in full at the time of purchase and / or installation and is produced when warranty se…

3, DISARMING To disarm the P165, simply insert and remove a valid Touchkey from the socket mounted on your dash. The red status LED will extinguish and the immobiliser is disarmed. If the engine is not started within 30-40 seconds the P165 will automatically arm. ARMING The P165 will automatically …

4, OVERRIDE The system can be overridden by means of a Personal Identification Number (PIN). Every unit is supplied with its own PIN. It is important to make a note of this PIN or keep the card supplied with the unit in a safe p1ace as it also has the PIN detailed on it. ** Any digit marked …