Daiwa Seaborg 500MR Operating Instructions Manual

37, 35 Functional setting operation (13. Display recalibration) Display revision You can recalibrate the counter should it not indicate an accurate depth compared to depth markings on your line. Example below is the case in which, though the counter shows 103 m, color markings on the line in…

15, 13 Line data input (With backing line) This method requires use of Daiwa braided line that is color coded to show length and has a total length greater than 100 m. Main line Backing line Tie 1. Run the backing line through the levelwind guide and tie it onto the spool. The levelwind threa…

32, Daiwa Seaborg 500MR 30 You can choose the waiting time between jigs. The interval time is set in seconds. The depth range for jigging is set in 1 m increments. If the range is set to zero, then jigging continues right up to the auto stop depth. 3. Waiting time 4. Jigging range (Preference set…

38, 36 Functional setting operation (14. How to fix the Rod Clamp) 1. Insert a washer between the frame and the bolt, and tighten the bolt to secure it. 2. Place the reel on the rod. Apply the rod clamp to the opposite side of the rod. Tighten the nuts with a coin, etc. to secure th…

3, DO NOT allow end of line to be wound onto the spool.This may cause synchronization with the levelwind to be lost, a condition that can damage the levelwind due to the reelʼs high power output. Should this happen, line should be removed from spool and rewound. After each trip, atta…

42, 40 Trouble shooting 23 9 2 2 5 2 27 28,29 28,29 27,31 2 20 21,22 20 20 35 26 10-16 Symptom Possible causes To do Ref. page Motor does not respond to the power lever Counter display does not appear. Inverse counter does not appear Jigging function does not respond The ree…