easyRAID Q08+F2R2 Hardware User Manual

12, 2 easyRAID Q08+F2R2 Serial ATA II Disk Array System 1 System Requirements – Host Interface The disk array system has dual 2Gbps Fibre Channel interface. Refer to the following sections to understand host interface system requirements. Fibre Channel Interface The easyRAID Q08+F…

9, easyRAID Q08+F2R2 Serial ATA II Disk Array System iii Preface – Important Safety Instructions, Care and Handling The appliance must be grounded. The disk array system is equipped with a 3-wire grounded type of power cord. This power cord will only fit into a grounded type …

25, 15 3Maintenance Replacing a Disk A disk failure is indicated when the Power/Error LED at the front of the drive tray turns red and the audible alert sounds. The LCD panel displays the failure with the symbol “R” or “W”. “R” indicates a disk failure or error, and “W”…

27, easyRAID Q08+F2R2 Serial ATA II Disk Array System 17 3 Maintenance – Replacing a Power Supply 4 Pull the power supply handle out. 5 Remove the faulty power supply by pulling the power supply handle A and pressing the release catch B at the same time. 6 Insert a new power supply. 7 Pu…

5, i Table of Contents Preface................................................................................................................... i Chapter 1 System Requirements Operating Environment ................................................................................…