Datamax I-Class Maintenance Manual

85, Removal and Replacement 4-29 2. Insert the Main Logic PCB between the Guides in the Card Cage then slide it forward until seated. 3. Reinstall the two previously removed screws and secure the Main Logic PCB in the Card Cage. 4. Reinstall the interface cable(s). 5. Verify the install…

64, Removal and Replacement 4-8 Replacement: 1. Carefully reconnect both cables to the Printhead. 2. Position the Printhead onto the Locating Pins in the Printhead Assembly. Printhead Printhead Assembly Locating Pins 3. Secure the Printhead to the Printhead Assembly with the Printhead Mounting Screw…

67, Removal and Replacement 4-11 4.4.1.1 Head Pressure Cams and Springs Removal: 1. Remove the Printhead Assembly; see Section 4.4.1. 2. Carefully pry the Clip from the Printhead Assembly. Also, remove the two Screws that secure the Ribbon Shield and then remove it from the Printhea…

53, Datamax I-Class Troubleshooting 3-15 Fault Messages (continued) Displayed Message Description Solution TOP OF FORM FAULT TOF was not detected within the maximum label length setting, or a TOF was unexpectedly detected.  Note: When the SENSOR TYPE is REFLECTIVE, this fault is given for an out …

75, Removal and Replacement 4-19 3. Remove the Rewind Hub and the Outer Bearing from the Rewind Housing. 4. Remove the Rewind Hub Clutch from the Housing (and to remove the Spur Gear, remove the Screw that secures the Idler Post to the Rewind Housing). Replacement: 1. Reinstall the Outer …