E-Bike 36V Service Manual

55, 2. Disconnect the taillight/brake light connector under the seat (Figure 20). 3. Remove the two taillight mounting nuts (Figure 21), and remove the taillight assembly from the seat bracket. 4. Fit a new taillight assembly in place, and secure it with the two taillight mounting nuts. Torque the n…

45, 2. Inspect the square hole in the crank arm (Figure 12). The flats of the hole should be straight and even. Replace the crank arm if its square hole shows signs of wear or damage. 3. Inspect the crank arm for cracks or other signs of wear. Pay particular attention to the area around the mount…

36, 3. Slide the shim onto the handlebar. Install the handlebar grip so the grip end is flush with the handlebar end. 4. Slide the shifter body against the grip shim. 5. Rotate the shifter body so the adjusting bar- rel is below the brake lever. Tighten the shifter clamp bolt to the specification…

49, 5. Remove the three left-side-cover screws. One is located behind the steering head (B, Figure 2), one is above the controller (A, Figure 4), and the third is toward the rear of the side cover (B, Figure 4). 6. Carefully, pivot the right side cover away from the E-Bike ® until the batter…

10, E-Bike 36V SX model 26 x 1.95 in., CSK, puncture resistant PE model 26 x 1.95 in., black with reflective stripe, puncture resistant Rims DH-17 Front 26 x 1.5 in., 14G x 32H, double wall Rear 26 x 1.5 in., 14G x 36H, double wall G3000 Front 26 x 1.5 in., 14G x 32H, double wall Rear 26 x 1.5 in., 14G x 36…

39, FIG. 16 17. Loosen the pinch-mechanism nut, and use the fourth-hand tool to pull the slack from the inner wire. 18.Torque the pinch-mechanism nut (B, Figure 4) to the specification in Table 4. Check that the inner cable is still contained within the groove in the pinch-mechanism plate. 1…