Ledj STAGE PAR 64 Operation & User’s Manual

6, LEDJ Eco LED 64 MASTER/SLAVE Operation modes Strobe Mode To set the unit in strobe mode, set dip switch 1 to ON and all others to the OFF position. Now use the sensitivity control to adjust the speed. Fade mode To set the unit in fade mode, set…

10, Notice: • Be sure to follow figures 2 & 3 when making your own cables. Do not connect the cable’s shield conductor to the ground lug or allow the shield conductor to come in contact with the XLR’s outer casing. Grounding the shield could cause a short circuit and erratic behaviour. Sp…

7, LEDJ Eco LED 64 CONTROL OPTIONS Daisy Chain Connection 1) Connect the (male) 3 pin connector side of the DMX cable to the output (female) 3 pin connector of the first fixture 2) Connect the end of the cable coming from the first fixture which will have a (fem…

3, Ledj STAGE PAR 64 LEDJ Eco LED 64 SAFETY IMPORTANT: The manufacturer will not accept liability for any resulting damages caused by the non-observance of this manual or any unauthorised modification to the equipment. • Never let the pow…

8, LEDJ Eco LED 64 CONTROL OPTIONS Set the start address using the group of dip switches located usually on the back of the fixture. Each dip switch has an associated value. Adding the value of each switch in the ON position will provide the start address. Determi…