Bellfires BM 21 Installation Manual

25, Bellfires® BM & BR 25 BM specific directions Cut 1" CERAFOIL pieces for masonry canopy, over lapping outside edges. (Fig. 9) with CERAFOIL tape. Adhere insulation to masonry canopy. (FIG.9A Make sure the CERA- FOIL pieces are 1” larger than the outside of the masonry canopy so t…

30, Bellfires® BM & BR 30 Using SUPER CEMENT refractory mortar, butter top of refractory dome. (Fig ). Place refractory turbo transition on top of refractory smoke dome, aligning inside back walls flush on both units. (Fig ). With 1” CERA- FOIL, insulate around refractory turbo transi…

20, Bellfires® BM & BR 20 Install the refractory fire box between wing walls and position flare exten- sions for proper centering. Remove side flares after firebox is properly centered. (FIG.5) Cut 1/4” CERAFOIL insulating blanket to shape of the two piece hearth, installing foil fac…

8, Bellfires® BM & BR 8 16” 9 ” 10” 11” 23 ” 25 ” BM 21 Tall 30 ” 8 ” 17” 23” 41 ” BM 21 Tall 46 ” BM 21 Tall & Standard 20 ” 12 ” 9” 13 ” 26 ” 28 ” BM 25 Tall 33 ” 8 ” 21” 27 ” 49” BM 25 Tall 54” BM 25 Tall & Standard 25” 4 ” 31 ” 4…

9, Bellfires® BM & BR 9 12 ” 20 ” 9” 14” 29 ” 28 ” BM 28 Tall 33 ” 8 ” 19 ” 31 ” 49” BM 28 Tall 54” BM 28 Tall & Standard 7” 12” 10” 7” 16” 32 ” 25 ” BM 21R Tall 30 ” 9 ” 17” 23” 47 ” BM 21R Tall 52 ” BM 21R Tall & Standard 31 ” 4 ” 20…

13, Bellfires BM 21 Bellfires® BM & BMR 13 A. Bellfires® fireplaces are not approved for use in mobile homes. B. There must be an air space clearance between the outermost portion of any section of the chimney system and any combustible surface. Although two inches is a typical clearance, adhere to the req…