Stelpro STCP Operation & User’s Manual

16, INSSTCP1010 Sensor Selection If you want to use the STCP thermostat of Stelpro Design with a temperature sensor already installed in the floor (other than the sensor supplied with this thermostat), you must contact the Stelpro Design customer service to validate the compatibility between the…

9, INSSTCP1010 This adjustment can be done from any of the three principal modes. Manual Mode (Man) From the Manual mode, you can manually adjust the thermostat set point by pressing down the + or - buttons to increase the value, or to decrease it. Please note that if th…

2, INSSTCP1010 1. Description The STCP electronic thermostat can be used to control heating floors with electrical current − with a resistive load − ranging from 0 A to 16 A at 120/208/240 VAC. It has an easy user interface and can manage up to four programming periods a day. It keep…

6, Stelpro STCP INSSTCP1010 6. Reinstall the front part of the thermostat on the mounting base andtightenthescrewatthebottomoftheunit; 7.Turnonthepower; 8. Set the thermostat to the desired setting (see the following section). 3. Operation 6…

19, INSSTCP1010 in the volatile memory and recovered when power is restored. Then, the thermostat enters a very low consumption mode and only displays the hour and day of the week. All the other functions are deactivated. The thermostat is self-sufficient for 2 hours. If the pow…