STEELE PRODUCTS SP-PT237 Owner's Manual

2, STEELE PRODUCTS SP-PT237 HAMMER DRILL 1/2” Assemble and Operating instructions Certificate Number: E222615 GRNERAL SAFETY INSTRUCTIONS WARNING! Read and understand all instructions. Failure to follow all instructions listed below may result in electrical shock, fire and/or serious personal injury…

3, ～Do not overreach while operating a power tool. Keep proper footing and balance at all times. Good balance and solid footing enables better control in unexpected situations. ～Always wear appropriate safety equipment. Always wear eye protection while operating a power tool. Use appr…

4, right, a hammer symbol will be visible to the left of the switch. The drill now adds an impact function to the drilling rotation. The impact function greatly speeds up the drilling of cement-based materials such as mortar, concrete, brick and block. Use this function only with …

5, Variable speed drills will double as a power screw driver by using screwdriver bits. The technique is to start slowly, increasing the speed as the screw runs down. Set the screw snugly by slowing to a stop. Prior to driving screws, pilot and clearance holes should be drilled. …

6, NO. Part Name NO. Part Name NO. Part Name 1 Power cord 15 6mm steel ball 29 Circlip for shaftΦ9 ㎜ 2 Rubber sleeve 16 Change knob 30 Big gear 3 Cord clip 17 Flat washer 31 Sanpring 4 Screw ST4.2×16 18 Stator 32 Bearing 6002 5 Electric capacity 19 Bear…