Asko D1976CSTM Installation Instructions Manual

10, Page 10 WARNING!  Before working on any electrical appliance, be sure the electrical power has been turned off at the breaker/fuse box. Refer to the illustration at bottom right for instruction references. 1. Remove the lower access panel with standard or 20 torx screwdriver. 2. Using nee…

4, Page 4 WARNING! Plumbing connections must comply with applicable sanitary, safety and plumbing codes in your area. The machine can be connected to either a hot or cold water supply. If a cold water supply is used, the washing times will be longer but the performance will not be…

6, Asko D1976CSTM Page 6 WARNING! Before working on wiring for any electrical appliance, be sure the electrical power has been turned off at the breaker/fuse box. WARNING! Disconnect electrical power supply and place a tag at the disconnect switch indicating that you are working on the circuit. WARNING! Electrica…

2, Page 2 TOOLS 1) Phillips No. 2 screwdriver 2) Flat blade screwdriver 3) Torx screwdriver size T 20 4) Adjustable wrenches (if you use copper fittings) 5) Open-ended wrench (1/2" [12 mm] or 5/8" [16 mm]) 6) Tape measure 7) Spirit level 8) Electric drill with 1” drill bit 9) Keyhole…

1, Page 1 AUTOMATIC HIGH LOOP The drain hose is fastened to the back of the machine at the best height. To eliminate potential drain problems, leave this hose in place. IMPORTANT! Read all of these instructions before installing the dishwasher. SAVE THESE INSTRUC…